Edge Lighting PSB-96W-010-24VDC, 96 Watt 24 Volt DC Power Supply - Manual (Page 3)

input 120VAC
WH (N)
BK (L)
input 0-10V
PUR
GRY
RED (24VDC+)
BLUE (RETURN-)
YELLOW (DIM RETURN-)
3
D
8: Connect the black controller wire to the 120 volt hot power
line wire with a wire nut.
9: Connect the white controller wire to the 120 volt neutral
power line wire and the white power supply wire with a
wire nut.
10: Connect the red controller wire to the black power supply
wire with a wire nut.
11: Connect the gray controller wire to the gray power supply
wire with a wire nut.
12: Connect the purple controller wire to the purple power
supply wire with a wire nut.
13: Make sure the power supply is grounded in accordance
with local electrical codes.
10
8
14: Use the "Low Voltage Wire Size Chart" below to determine
the proper wire size connecting the power supply to the
LED soft strip.
15: Run the proper size, red and yellow wires from the LED soft
strip to the power supply case.
16: Cap the blue wire with a wire nut, this wire is not used.
E
17: Connect the red wire coming from the power supply to the
red wire of each LED soft strip.
18: Connect the yellow wire coming from the power supply to
the black wire of each LED soft strip.
LED SOFT STRIP
15
NOTE: Use only 24 volt Warm White LED soft strip with
this power supply.
NOTE: For multiple parallel runs, do not exceed 32' total
length.
9
13
12
input 120VAC
WH (N)
BK (L)
input 0-10V
PUR
GRY
RED (24VDC+) BLUE (RETURN-) YELLOW (DIM RETURN-)
VOLTAGE
DROP
UP TO 33FT
3%
34FT-52FT
WIRE SIZE
VOLTAGE AT END
OF THE WIRE
14 AWG
23.28 VDC
53FT-86FT 87FT-130FT
12 AWG
23.29 VDC
10 AWG 8 AWG
23.28 VDC 23.28 VDC
WIRE LENGTH
IN FT
96W, 24VDC LOW VOLTAGE WIRE SIZE CHART
16
18
17