Edge Lighting PSB-2X96W-010-24VDC, 192(2x96) Watt 24 Volt DC Power Supply - Manual (Page 3)

input 120VAC
WH (N)
BK (L)
input 0-10V
PUR
GRY
RED (24VDC+)
BLUE (RETURN-)
YELLOW (DIM RETURN-)
input 120VAC
WH (N)
BK (L)
input 0-10V
PUR
GRY
RED (24VDC+)
BLUE (RETURN-) YELLOW (DIM RETURN-)
3
D
8: Connect the black controller wire to the 120 volt hot power
line wire with a wire nut.
9: Connect the white controller wire to the 120 volt neutral
power line wire and white wire of each power supply with a
wire nut.
10: Connect the red controller wire to the black wire of each
power supply with a wire nut.
11: Connect the gray controller wire to gray wire of each power
supply with a wire nut.
12: Connect the purple controller wire to each purple wire of
each power supply with a wire nut.
13: Make sure the power supply is grounded in accordance
with local electrical codes.
14: Use the "Low Voltage Wire Size Chart" below to determine
the proper wire size connecting the power supply to the
LED soft strip.
15: Run the proper size, red and black wires from the LED soft
strip to each power supply case.
16: Cap the blue wires with a wire nut, this wire is not used.
E
17: Connect the red wire of one power supply to the red wire
of one LED soft strip run (a group of maximum 96 watt LED
soft stripes) with a wire nut. Connect the yellow wire of the
same power supply to the black wire of these LED soft
stripes.
18: Repeat step 16 for the other power supply and the other
group of LED soft strips.
15
NOTE: Use only 24 volt Warm White LED soft strip with
this power supply.
VOLTAGE
DROP
UP TO 33FT
3%
34FT-52FT
WIRE SIZE
VOLTAGE AT END
OF THE WIRE
14 AWG
23.28 VDC
53FT-86FT 87FT-130FT
12 AWG
23.29 VDC
10 AWG 8 AWG
23.28 VDC 23.28 VDC
WIRE LENGTH
IN FT
96W, 24VDC LOW VOLTAGE WIRE SIZE CHART
input 120VAC
WH (N)
BK (L)
input 0-10V
PUR
GRY
RED (24VDC+) BLUE (RETURN-)
YELLOW (DIM RETURN-)
input 120VAC
WH (N)
BK (L)
input 0-10V
PUR
GRY
RED (24VDC+)
BLUE (RETURN-) YELLOW (DIM RETURN-)
LED SOFT STRIP
16
16
17
18
18
17
11
12
9
8
10
13