Edge Lighting Crystal Spirits - Manual (Page 2)

D
8"
10: Leave 8" of the clear cord exposed behind the canopy for
power connection. Trim off the excess clear cord.
11: From the end of the clear cord, separate the wires from the
cord web for 4" and strip the ends.
10 E
12: Mount the crossbar assembly to the electrical box holes
with the two #8-32 screws provided.
CROSSBAR
ASSEMBLY
#8-32 SCREW
13: Make sure the power to the electrical box is off.
14: Make sure that the canopy is grounded in accordance with
local electrical codes.
15: Connect the grooved surface clear wire to the neutral
power wire with a wire nut.
16: Connect the smooth surface clear wire to the hot power
wire with a wire nut.
NOTE: It is recommended a person to hold the fixture while the
electrician connects the power to the fixture.
11
12
F
CROSSBAR
ASSEMBLY
14
16 15
2
17: Place all wires and wire nut connections inside the canopy.
18: Align and slide the canopy holes onto the threaded studs.
While holding the canopy, tighten the two thumb nuts to
secure the canopy in place.
CANOPY
THREADED
STUD
THUMB NUTS
G
17
18
18