Edge Lighting Crystal Veil - Manual (Page 2)

D
5:
6:
Install the six pieces of crystals marked “C” into the hoops
located under each socket assembly so that one end is
hooked into one socket assembly hoop and the other end
into the adjacent socket assembly hoop.
Install the six pieces of crystal marked “B” into each socket
assembly hoop. Each socket assembly hoop will hold three
key rings when all crystals are attached (one “B” and two “C”
crystals).
2
"C" CRYSTAL
"B" CRYSTAL
5 6
E
"A" CRYSTAL
7: Install the six pieces of crystal marked “A” into each hoop at
the top end of the curved stems.
CURVED STEMS
G
2: Loosen the nut on the adjustable link and remove it from the
hook bushing.
3: If not adjusting the fixture height, then omit steps 4 through
6.
CORD
ADJUSTABLE LINK
CHAIN
HOOK
BUSHING
2
FABRIC SHADE
F
H
CANOPY
1
1: Determine the desired fixture height (H), from the bottom of
the crystals to the top the canopy.
CRYSTAL
Install the Fixture
4
CLEAR CORD
4: Remove the adjustable link from end of the chain.
5: Use two pairs of pliers to open the link closest to desired
height. Remove the excess links from the chain. Make sure to
consider the adjustable link as part of the fixture height.
H
ADJUSTABLE LINK
5
7