Edge Lighting Vega Round - Manual (Page 3)

3
1: Feed the power wires through the mounting plate center
hole.
2: Secure the mounting plate to the electrical box holes with
the two #8-32 screws provided.
NOTE: Make sure the glass shade is detached.
Install the Fixture
G
MOUNTING
PLATE POWER WIRE
#8-32
SCREW
ELECTRICAL
BOX HOLE
1
2 2
NOTE: Use the provided universal crossbar if the mounting
plate holes do not line up with the electrical box holes.
H
3
4
5
3: Make sure the mounting plate and the bare wire is grounded
in accordance with local electrical codes.
4: Connect the clear wire with a white tag to the neutral power
wire with a wire nut.
5: Connect the clear wire with a black tag to the hot power wire
with a wire nut.
D I
MAGNET
COVER
PLATE
6
6
6: Slide the cover plate up against the mounting plate, the
magnets will hold the cover plate in place.
6