Edge Lighting Air LED - Manual (Page 2)

2
4: Connect the white LED driver wire to the neutral power wire
with a wire nut.
5: Connect the black LED driver wire to the hot power wire with
a wire nut.
NOTE: It is recommended that one person holds the canopy
while the electrician installs it.
D
6: Place all wires and wire nut connections inside the electrical
box.
7: Mount the canopy to the crossbar with the two Phillips
screws and lock washers.
E
CANOPY
4
CROSSBAR 5
ELECTRICAL BOX
CANOPY
PHILLIPS
SCREW
LOCK
WASHER
8: To make any minor adjustments to the fixture height, p
9: Secure the crystal accessary to the fixture frame by
tightening the thumb nut to the threaded stud.
ush
the tabs on the canopy to slide the fixture frame up and
down until the desired height is achieved. Release the tab to
lock the aircraft cable in place.
F
CANOPY
AIRCRAFT
CABLE
TAB
6
7
CRYSTAL
ACCESSARY
THREADED
STUD
9
8
THUMB
NUT
NOTE: The fixture contains integrated LED lamps rated for
50,000 hours. It consumes a total of 14 watts.