Edge Lighting Grazie - Manual (Page 3)

G
CANOPY
THREADED
STUD
THUMB NUTS
16: Place all wires and wire nut connections inside the canopy.
17: Align and slide the canopy holes onto the threaded studs.
While holding the canopy, tighten the two thumb nuts to
secure the canopy in place.
1: For each socket, screw the lamp base completely into the
socket.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 25 Watts, Type G16.5, E12 candelabra base, half
chrome lamp for each socket.
H
Install the Lamps & Glass
Ornaments
3
16
17
I 2: Squeeze the key ring to open the ends. Slide one end
through a glass ornament.
KEY RING
GLASS
ORNAMENT
3: Squeeze the key ring to open the ends and slide one end into
a socket housing spring.
4: Repeat steps 2 and 3 for the remaining glass ornaments.
J
2
2
3
KEY RING
SPRING
SOCKET HOUSING