Edge Lighting Mint Round - Manual (Page 2)

2
ELECTRICAL
BOX
BACKPLATE 6: Place all wires and wire nut connections inside the electrical
box.
7: Mount the backplate to the electrical box holes with the two
#8-32 screws and washers provided.
#8-32 SCREW
WASHER
6
7
C
Install the Lamp & Glass Shade
1: Push the lamp completely into the socket.
D
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
NOTE: The G9 lamp has an internal glass envelope and is safe to
be used without a lamp shield.
LAMP
1
SOCKET
BACKPLATE
NOTE: Use only fingers and a soft cloth to install the lamp.
Use MAX 40 Watt Type T4, G9 Base, Bi-Pin
Halogen Lamp.
2:
locks in place.
3: Tighten the two M4 set screws with the 2mm Allen wrench.
Replace and screw the glass shade into the backplate until it
E
BACKPLATE
GLASS SHADE
M4 SET
SCREW
2
ELECTRICAL
BOX
3
3
2MM ALLEN
WRENCH
7
3