Edge Lighting Vanilla Sky Round - Manual (Page 2)

ROUND GLASS SHADE
1
1
SPRING CLIP
D
THUMB NUT
THREADED
STUD
ELECTRICAL
BOX
CEILING
6
7
2
Install the Lamp & Glass Shade
6: Place all wires and wire nuts connections inside electrical box.
7: Align and push the canopy holes onto threaded studs and
tighten the thumb nuts completely to secure the canopy in
place.
F
ROUND GLASS SHADE
2
1: Push the lamp pins completely into the socket holes.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 9 Watt Type 2G7 Base Compact
Fluorescent Lamp For Each Socket.
E
LAMP
SOCKET
1
1
2
2
SPRING CLIP
2: Place the edge of the round glass shade into two adjacent
spring clips. Slightly push the glass shade against these two
spring clips and simultaneously slide the other edge into the
other two spring clips. Make sure that the round glass
shade sits properly into the four spring clips.
1: While holding the glass shade unhook one spring clip at a
time until the glass shade is free.
2: Remove the old lamp and then follow "Install the Lamp &
Glass Shade" steps to complete lamp replacement.
Replace the Lamp
G
2