Edge Lighting Port LED Components User Manual

Sun 3 & port spring clips, Install the spring clips, Installation preparations

Advertising
background image

SAVE THESE INSTRUCTIONS!

- The Spring Clips (SC-WO) are an accessory that are used
with Sun3 and Port fixtures. When they are installed in a
porch wood surface.

Installation Instructions for

Sun 3 & Port Spring Clips

904-SC-WO-01

IMPORTANT INFORMATION

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

1

© 2011 Edge Lighting. All Rights Reserved.

SC-WO

Install the Spring Clips

A

1: Remove the two Phillip screws from the bottom of the
fixture trim tab.

NOTE:

underground cables and outdoor rated wire nuts when no conduit
is used to power the fixture(s).

For outdoor installation, use UL listed type UF

SPRING CLIP

B

1: Mark a point on the surface where the fixture opening is
going to be located.

2: Cut out the marked location with a 2-7/8" circular saw for
SUN3 or a 2" circular saw for Port fixture.

MOUNTING HOLE
IDENTIFICATION

SUN3 HOLE

PORT HOLE

FIXTURE
TRIM TAB

PHILLIPS SCREW

2

2

Installation Preparations

NOTE:

provided with each fixture.

For detailed wiring information refer to the instructions

2 or 2 7/8"
HOLE

SURFACE

NOTE:

the outer hole is to be used with Sun3 fixture.

The inner hole on spring clip is to be used with Port and

700mA

120V NEUTRAL (WHITE)

120V HOT (BLACK)

POWER

SUPPLY

-

+

Wiring Diagram

FIXTURE

2:
diagram for clarification) with the trim tab hole. Replace and
tighten the Phillips screw. Before installing fixture,
slightly rotate the spring clips towards each other to
make it easier to install (refer to the drawing).

For each spring clip, align one of the two holes (refer to

2

TURN SPRING CLIPS

TOWARD EACH

OTHER BEFORE

INSTALLATION

SPRING CLIP

FIXTURE

2

Advertising
This manual is related to the following products:
Table of contents