Install the lamp and shade – Edge Lighting Garbo User Manual
Page 2
2
7: Place all wires and wire nut connections properly inside the
electrical box.
8: Align and insert the two #8-32 screws through the fixture
screw holes into the crossbar inner threaded holes. Tighten
the two #8-32 screws to secure the fixture in place.
D
Install the Lamp and Shade
E
LAMP
SOCKET
1
LAMP PIN
Use
MAX 17
Watt Type T8, Compact
Fluorescent Lamp.
1: Push one side of the lamp into one socket by sliding the lamp
pins completely into the socket slot, and then insert the other
side to the other socket. Secure lamp in place by turning
clockwise.
CAUTION:
To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
1
F
TAB
SLOT
PHILLIPS SCREW
2
3
2: Align the glass shade slots with the fixture tabs. Push the
glass shade onto the fixture and slide it to lock in place.
3: Secure the glass shade to the fixture by tightening the
Phillips screw.
8
7
CANOPY
FIXTURE
8
NOTE:
NEMA fluorescent lamp manufacturers recommend to
reduce possible flicker or instability when new dimming systems
are comissioned, lamps should be operated at the ballast's
maximum light output setting overnight (approximately
12 hours).