Edge Lighting Greta - Manual (Page 2)

NOTE: It is recommended a person to hold the fixture while the
electrician connects the power to the fixture.
E
3: While holding the fixture feed the socket plate wires into the
backplate center hole.
4: Make sure that the crossbar is grounded in accordance with
local electrical codes.
5: Connect the white fixture wire to the neutral power wire with
a wire nut.
6: Connect the black fixture wire to the hot power wire with a
wire nut.
4
5 6
F
CROSSBAR
ADJUSTMENT
BACKPLATE
SCREW
MOUNTING
BAR
2
7: Align the backplate screw holes to the electrical box
mounting holes, and place the backplate on wall to mark
the anchor location.
8a: If mounting fixture centered: mark the end holes of the
mounting on the wall. These marked holes are for
anchors (not provided).
8b: If mounting fixture off centered: slightly loosen the
two backplate screws and slide the mounting bar to the
desired position and tighten the backplate screws. Mark
the end holes of the mounting on the wall. These marked
holes are for anchors (not provided).
7
BACKPLATE
END
HOLE
8b
PHILLIPS SCREW
CROSSBAR
BACKPLATE
C 3:
backplate to remove the crossbar. These screws will
be used at a different location later during
installation. Unscrew the two Phillips screws in the center of the
3
Install the Fixture
CROSSBAR
D
ELECTRICAL
BOX HOLE
INNER
THREADED
HOLE
#8-32 SCREW
1 1" APART
1:
2:
horizontally (to mount the Greta for vertical position), or
vertically (to mount the Greta for horizontal position).
Secure the crossbar to the electrical box with the provided
two #8-32 screws.
Feed the power wires through the crossbar center cutout.
Level the two inner threaded holes (spaced 1" apart) either
3
8a 8a
SOCKET PLATE