Edge Lighting Mr. Square User Manual
Page 2
2
7: Feed the power wires through the crossbar assembly nipple.
8: Make sure the crossbar assembly is grounded in accordance
with local electrical codes.
9: Mount the crossbar assembly to the electrical box holes with
the two #8-32 screws provided.
D
#8-32 SCREW
ELECTRICAL BOX
POWER WIRE
CROSSBAR ASSEMBLY
8
9
9
7
C
M4 SET
SCREW
2MM ALLEN
WRENCH
5
CANOPY
6
GASKET
FIXTURE
POWER
WIRES
5: From the bottom of the fixture loosen
the M4 set screw with the 2mm Allen wrench .
6: Carefully, remove the canopy and gasket from the fixture.
(Do Not Remove)
E
CROSSBAR ASSEMBLY NIPPLE
GASKET
CANOPY
CENTER
HOLE
ELECTRICAL BOX
LOCK
WASHER
NUT
11
10
10: Feed the power wires through the gasket and canopy
center hole respectively.
11: Secure the canopy to the crossbar nipple with the lock
washer and nut.
F
13
12
12: While holding the fixture, connect the white fixture wire to
the neutral power wire with a wire nut.
13: Connect the black fixture wire to the hot power wire with a
wire nut.
NOTE: If necessary, trim the fixture wires.