Edge Lighting Regal - Manual (Page 2)

2
E 7: Make sure that the crossbar is grounded in accordance with
local electrical codes.
8: Connect the white fixture wire to the neutral power wire with
a wire nut.
9: Connect the black fixture wire to the hot power wire with a
wire nut.
8
9
F
10: Secure the fixture body to the crossbar assembly by
tightening the hex nuts and lock washers.
HEX NUT
LOCK WASHER
FIXTURE BODY
10
10
G
SOCKET
Use MAX 24 Watt Type 2G11 Base Compact
Fluorescent Lamp.
11: Push the lamp pins completely into the socket holes and
secure it by snapping into the spring clips.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
LAMP
SPRING CLIP
11
H
FIXTURE BODY
GLASS DIFFUSER
12
12
12: Insert the glass diffusers between the fixture body and
inner bracket.
I
SPRING
CLIP
REFLECTOR
INNER
BRACKET
SPRING CLIP
13
13
13
13: Align and insert the reflector ends into the inner bracket
and secure it in place by replacing the spring clips.
J
THUMB SCREW
14
COVER
FIXTURE BODY
14
THREADED RODS
14:
threaded rods to secure the cover in place. Replace the cover and tighten the two thumb screws to the
7