Edge Lighting T-Bar Clip User Manual
Page 2
2
3: Slide the T-Bar clip adapter(s) into the Cirrus channel.
E
FRONT VIEW
TOP VIEW
G
4: Align the T-bar clip adapters evenly apart and tighten the
#6-32 set screws on each T-bar clip adapter with a 1/16"
Allen wrench.
F
3
3
CIRRUS CHANNEL
CIRRUS CHANNEL
T-BAR CLIP ADAPTER
T-BAR CLIP ADAPTER
CEILING
CIRRUS
CHANNEL
T-BAR CLIP
ADAPTER
POST
5
H
ADAPTER
POST
0.05" ALLEN
WRENCH
#4-40 SET
SCREW
#6-32 SET
SCREW
1/16" ALLEN
WRENCH
T-BAR CLIP
ADAPTER
5: If necessary, slide the T-bar clips to align with the T-bar clip
adapters. Align and insert the T-bar clips adapter posts into
the threaded studs.
6: Tighten the #4-40 set screws with a 0.05" Allen wrench on
each part.
4
6
THREADED
STUD
I
END CAP
CIRRUS CHANNEL
7: Replace the end cap to the end of the channel and t
two #4-40 set screws with a 0.05" Allen wrench.
ighten
NOTE: Refer to instructions provided with Cirrus channel to
install power.
7