Edge Lighting Sun 3 LED Components - Manual

NOTE:
trim to be water proof.
Do not remove the glass retainer ring which makes the
Installation Instructions for STEP LIGHT KITS SUN3-LL & PORT-LL
904-SUN3-LL-03
Install the Lens
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
LED BODY
© 2011 Edge Lighting. All Rights Reserved.
1: Unscrew to remove the LED body from the trim.
A
SUN3-LL_
SAVE THESE INSTRUCTIONS!
IMPORTANT INFORMATION
- The SUN3-LL & PORT-LL are the accessory step light kits
that are used with Sun3 and Port fixtures respectively.
- The SUN3-LL and the PORT-LL come with a Micro Louver
Lens for controlling the glare, a 20 degree beam tilt film
for controlling the beam light, a neutral density film (gray)
to reduce the light level to 50%, a warm white film
(amber) to convert the light level to 2700K and a very
warm white film (yellow) to convert the light level to
2500K.
- The SUN-LLH & PORT-LLH do not come with any lenses or
films.
TRIM
1
2: Using fingers remove the retainer ring inside the trim. If
necessary use a flat screw driver or pair of pliers to start.
B
2
TRIM
RETAINER RING
GLASS RETAINER RING
PORT-LL_
1