Edge Lighting Vision 3 - Manual (Page 3)

3
E
HOUSING
OPENING
TRIM
7: Place all wires inside the housing and insert the top spring
clip into the housing.
8: Bend the bottom spring clip of the trim towards the housing
while pushing it into the housing.
BOTTOM
SPRING CLIP
9: From the inside of the trim, push the back end of the glass
disk upwards until the front end of glass disk slides out of
the metal frame.
10: Carefully pull the socket assembly out.
11: Push the lamp pins completely into the socket assembly
holes.
12: Replace the socket assembly completely into the trim
housing.
13: Slide the glass disk half way into the metal frame opening
and rotate the front up while inserting the remaining
portion in.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 20 Watt Bi-Pin Halogen Lamp.
NOTE: Use only fingers and a soft cloth to install the lamps.
8
8
7
GLASS DISK
METAL FRAME
TRIM
LAMP
SOCKET
ASSEMBLY
10
11
TRIM
G
13
F
9