Edge Lighting SS1 RGB Soft Strip 1.5W, 24V High Output - Manual

SS1-24V-_-RGB
Installation Instructions for Soft Strip LED 1 Watt 24 Volt RGB
904-SS1-24V-RGB-05
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
IMPORTANT INFORMATION
- This product is ETL listed for indoor locations.
1
Install the Soft Strip
1:
installed. (Do not install it in an enclosed area)
2: For all surfaces other than aluminum, use the provided
aluminum heat sink tape (SS-HR-F) to avoid overheating
which may cause the RGB LEDs to fail.
3: Remove the backing from the aluminum heat sink tape
(SS-HR-F) and firmly press it down where the RGB LED soft
strip is going to be mounted.
Clean the area thoroughly where RGB LED soft strip will be
A
1
SURFACE
ALUMINUM HEAT
SINK TAPE (SS-HR-F)
3
2
PAPER BACKING
4: Align the RGB LED soft strip power wires so that the black
wire (side of connector with dot) of the power feed pin
connects to 24VDC soft strip pin. The green, red and blue
power feed pins will automatically be connected to G, R, & B
soft strip pins respectively.
B
RGB SOFT STRIP
24VDC
G
R
B
RGB SOFT STRIP POWER
WIRE FEMALE END
4
C
RGB LED SOFT STRIP
5
6
ALUMINUM HEAT
SINK TAPE (SS-HR-F)
RGB SOFT STRIP POWER
WIRE FEMALE END
PAPER
BACKING
5: Push the RGB soft strip power wire female end onto the RGB
soft strip male end connector.
6: Carefully remove the backing from the RGB LED soft strip,
make sure not to remove the tape from the soft strip. Firmly
press down the adhesive portion of the soft strip onto the
aluminum surface while removing the rest of the backing,
making sure there are no air bubbles that can cause surface
irregularities.
NOTE: The soft strip LEDs are rated for 40,000 hours when
using the aluminum heat sink tape (SS-HR-F).
NOTE: The adhesive tape of the aluminum heat sink needs to
be affixed on smooth clean surfaces (2" minimum). The
adhesiveness of the tape does not work well with porous,
textured, or unfinished wood surfaces, soft strip clips are
required (sold separately).
NOTE: Avoid bending the soft strip in sharp vertical angles which
may damage the LEDs. Soft Strips do not bend horizontal. Use
proper directional connectors for horizontal turns.
100147866CHI-004
SUITABLE FOR
UNDER-CABINET &
CLOSET APPLICATIONS
CLASS 2 WIRING