Edge Lighting SS3 RGB Soft Strip 2.6W, 24V High Output - Manual (Page 2)

2
D
7: Add the other piece of RGB soft strip by simply connecting
female end of the soft strip to the male end of the new soft
strip directly or with interfacing of the directional connectors.
8: The 4" long RGB soft strips can be used for fine adjustments.
FEMALE END OF
RGB SOFT STRIP
MALE END OF
RGB SOFT STRIP
7
DIRECTIONAL
CONNECTOR
7
E
ALUMINUM TAPE
11
RGB LED SOFT STRIP
DVR-RGB-60
DIRECTIONAL
CONNECTOR
END CAP
9
10
RGB SOFT STRIP
9: Use the optional end cap to cover the end of the soft strip.
10: The excess amount of RGB soft strip can be cut by the
indicated sections of the run with a pair of scissors. Once
the soft strip is cut, it cannot be extended.
11: Install the power supply by referring to the instructions
provided with the power supply.
NOTE: SS3 RGB soft strip consumes on average 2.6 Watt per foot.
F
1: To remove the tape residue from back of the strip apply
moderate amount WD-40, or Goo Gone, or a mixture of
warm water and lemon oil to the corner of a clean, dry
towel. Gently buff the area containing the adhesive residue
with small circular motion until it is completely removed.
2: From one side of the tape gently remove a few inches of the
backing. Attach the adhesive tape to the back of the soft
strip and apply moderate pressure to affix the tape. Continue
this step a few inches at the time until the entire adhesive
tape is attached to back of the soft strip.
3: Refer to the steps on 1 through 11 to reinstall the soft strip.
NOTE: If relocating the installed soft strip, make sure that the
adhesive tape on back of the soft strip covers the entire strip. The
adhesive tape on back of the soft strip isolates the strip from the
conductive heat sinks. Damaged or inconsistent adhesive tape may
cause the contacts on the back of the strip to come in contact with
the conductive heat sink which will cause the strip to short and
burn. Call Edge Lighting to get replacement adhesive tape and
aluminum heat sink tape (SS-HR-F)
SOFT STRIP
ADHESIVE TAPE
REMOVE SOFT STRIP
TO RELOCATE
APPLY ADHESIVE REMOVER
AND THEN BUFF OFF
ADHESIVE TAPE
ADHESIVE BACKING
ADHESIVE
BACK SIDE OF
SOFT STRIP
1
2
Relocating Soft Strip (Optional)