Edge Lighting PSB-100W-24VDC-RGB, 100 Watt 24 Volt DC Power Supply - Manual (Page 3)

C
M
3
10: Install a red wire from the power supply to DVR-RGB-60
"VDC+" red terminal and a black wire from power supply
to DVR-RGB-60 "VDC-" blue terminal.
11: Connect one end of a data wire (blue with white stripes
wire) to controller "LEDSYNC OUT–" terminal. Connect the
other end into the DVR-RGB-60 "DMX in –" terminal.
12: Connect one end of a data wire (white with blue stripes
wire) to controller "LEDSYNC OUT+" terminal. Connect the
other end into the DVR-RGB-60 "DMX in +" terminal.
13: Connect one end of a data wire (bare shield wire) to
controller "LEDSYNC SHIELD" terminal. Connect the other
end into the DVR-RGB-60 "DMX in shield" terminal.
10
EXT in- EXT in+
VDC- VDC+
DMX in + DMX in - DMX in shield LEDSync out + LEDSync out- LEDSync out shield
12
CONTROLLER
DVR-RGB-60
POWER SUPPLY
11
12
DO NOT
USE
NOTE: "DMX in+", "DMX in-", "EXT in+" & "EXT in-",
controller terminals are not used on controller.
M
CONDUIT
15
16
17
D
14: Run the line voltage power wires into the power supply.
15: Connect the hot power wire to black power supply wire
and black wire coming from the controller power supply
with a wire nut.
16: Connect the neutral power wire to white power supply wire
and white wire coming from the controller power supply
with a wire nut.
17: Make sure the green transformer wire is grounded in
accordance with local electrical codes.