Edge Lighting Soft Line indirect LED lighting system, featuring Soft Strip - Manual (Page 3)

3
12: Slide the adjustable standoff ring onto the standoff rod.
Make sure it passes mid point of the standoff rod.
13: Rotate the ring so that the standoff post is facing towards
the cable post. Tighten the M4 set screw on the ring with
2MM Allen wrench to lock it in place.
14: Pull the aircraft cable taut so that the standoff rod is
straight. To unlock the aircraft cable push the tab.
15: Repeat steps 7 through 14 for all other soft line standoffs.
16: Install the soft line turnbuckles and additional standoffs as
required.
G
ADJUSTABLE
STANDOFF RING
STANDOFF ROD
12
13
OUTRIGGER ROD
HOUSING
13
M4 SET
SCREW M4 SET
SCREW
2MM ALLEN
WRENCH
AIRCRAFT CABLE
WALL
H
17
guider bracket. : Make sure the soft strip sits properly in the Soft Line
OUTRIGGER
17
NOTE: To avoid standoff shadows on the wall, install the soft
strip only on the straight sections of the soft line. Run the power
cables near the straight sections or use the flat power joining
strips
included with the power cable. (SS-CPT-XX)
GUIDER
BRACKET
14 STANDOFF POST
CABLE POST
TOP VIEW
STRAIGHT SECTION
3" FLAT POWER
JOINING STRIP
POWER FEED
CONNECTOR
6" FLAT POWER
JOINING STRIP
FLAT POWER
JOINING STRIP FLAT POWER
JOINING STRIP
FLAT POWER JOINING STRIP
Is included in a 3", 6", & 12" length and
can be connected to one in another.
I
18: Pull the aircraft cable on all the soft line standoffs taut so
that the standoff rods are all straight before tightening the
turnbuckles adjustments links (refer to the turnbuckle
instructions).
19: Trim off excess aircraft cable.
SOFT LINE
SOFT LINE
STANDOFF
AIRCRAFT
CABLE
TOP VIEW
18