Edge Lighting Heat Sink Reflector Flexible L-Channel User Manual

Flexible l shaped heat sink reflector, Install the reflector, Installation instructions for

Advertising
background image

SS-HR-LFX-_

Installation Instructions for

Flexible L Shaped Heat Sink Reflector

1

904-SS-HR-LFX-01

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

© 2011 Edge Lighting. All Rights Reserved.

SAVE THESE INSTRUCTIONS!

- This product can be mounted as floor reflector or ceiling
reflector.
- This installation shows a typical floor installation.

IMPORTANT INFORMATION

B

3: If necessary, mark the size of the reflector.

4: Cut the excess reflector.

5: Clean the burrs around the the cut sections.

3

REFLECTOR

Install the Reflector

CURVED WALL

A

FLOOR

CURVED REFLECTOR
INSTALLATION

1: Determine the location where the reflector will be installed.

2: Using a tape measure determine the reflector size (A).

1

NOTE: Avoid bending the soft strip in sharp horizontal angles
which may damage the LEDs. Use the proper power connectors.

C

6: Clean the area thoroughly on the reflector where the soft
strip LED will be installed.

7: Remove the backing from the soft strip LED and firmly press
down making sure there are no air bubbles that can cause
surface irregularities.

REFLECTOR

SOFT STRIP LED

7

D

#6 SCREW

REFLECTOR

8

8: Secure the reflector to the surface using the provided #6
screws.

9: Refer to the power supply instructions to power the LED soft
strip.

8

NOTE: For sections longer than 3ft use multiple flexible heat
sinks.

Advertising
Table of contents