Edge Lighting Heat Sink Reflector L-Shaped & Flat Channel - Manual

SS-HR-L-_
Installation Instructions for L Shape Reflector
1
904-SS-HR-L-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2009 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
Install the Reflector
1: Determine the location where the reflector will be installed.
2: Using a tape measure determine the reflector size.
A
2
TAPE MEASURE
B
UNDER CABINET
3: Mark the size of the reflector.
4: Cut the excess reflector with a hacksaw.
5: Clean the inside and the outside burrs of the cut sections.
3
REFLECTOR
4
REFLECTOR