Edge Lighting 45° Light Channel 24V High Output User Manual

Light channel 45, Install the light channel, Installation instructions for

Advertising
background image

Installation Instructions for

Light Channel

45°

904-LC45-24V-01

Install the Light Channel

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

© 2013 Edge Lighting. All Rights Reserved.

SAVE THESE INSTRUCTIONS!

-

-

45 degree channel comes 12" to 120" long in a single

piece. Multiple 45 degree channels can be connected
together in series or parallel by connecting the 8ft pigtail
wires. These wires are rated for CLASS 2 (through the
wall) installation. Maximum 25' of the 45 degree channels
could be connect together when TEB-75L-24DC (Electronic
low voltage dimming) power supply is used, or 40' if the
PSB-96W-010-24VDC (0-10 dimming) is used.

This instruction shows typical installation.

IMPORTANT INFORMATION

A

1: Determine the location for the Light Channel.

2: Place the clips on the surface every 20" (measure from the
the center slot of the mounting clip) and mark the screw
locations.

LC45-24V-_

20"

AWAY

(TYP)

WOOD

MOUNTING CLIP

1

2

2

NOTE:

Remote power supply must be installed within 40 feet.

The low voltage 24VDC, Class 2 Wires must be present before
installing the channel. Refer to the installation instructions
provided with the power supply or general diagram on page 2.

1

LC45C-24V-_

B

SURFACE

3

4

ANCHOR

3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.

4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.

NOTE:

mounting the clips to a wood surface directly. ANCHORS ARE
NOT PROVIDED.

Steps 3 to 4 are for drywall mounting. Omit these steps if

5: Line up the mounting clips to the anchors and secure it to
the anchors by tightening the three #6 screws to each clip.

C

#6 SCREW

MOUNTING
CLIP

5

5

Advertising
Table of contents