Edge Lighting Light Channel, Millwork 12V User Manual
Page 2
Advertising
2
E
6: Drill one end of the slot with 7/32 bit to run the light channel
wire.
7: Feed the wires through the hole and snap the light channel
into the slot, make sure all clips are tight. If necessary slide
the mounting clip to the appropriate area.
8: Follow the instructions provided with the power supply to
power up the light channel.
SLOT
LIGHT CHANNEL
7
MOUNTING PLATE
7
D
POWER CORD
CUT
5
5
LIGHT CHANNEL
5: Cut the other end of the power cord (male or female) and
discard it. Strip the wire end for connecting it to the power
supply.
Advertising