EXEDY Standard Multi User Manual

Page 13

Advertising
background image

M300 -

13

-

エンジン側パイロットに、芯出しバーをセットし各ディスクのスプラインの歯筋を揃えてセンターを出
し構成図 NO.①のクラッチカバーAssy を締め付け固定します。
芯出しバーには純正のメインドライブシャフトの使用を推奨します。
Set the centering bar to the engine side pilot. Then, align the tooth traces of the splines of the discs for

centering, and tighten the clutch cover Assy No. 1 in the structural drawing to fix it.

The genuine main drive shaft is recommended for this process.

注意
CAUTION

各ディスクの歯筋及びセンターが合っていないと、T/M 組み付けが困難になり、
またディスクの破損の原因になります。
If the centers are not aligned, it will be difficult to assemble the T/M and it will

cause damage to the discs.

構成図⑦のボルト締め付けトルク:27∼29Nm {2.8∼3.0kgm}
Specified torque of bolt No. 7:
œ ボルトの締め付けが不均一な場合(一気にしめた場合)切れ不良やジャダー発生の原因に

なります。

Unequal bolt tightening will cause disengagement problems and judder/shudder.

6.

ボルト締め付け後、レバーの高さが均等にそろっているか確認して下さい。
もし、不均一な場合、再度「項目 3」よりやり直して下さい。

Confirm that lever height is equal after tightening. If it is not equal, then restart from item 3.

7. T/M を再組付けします。

プル式の場合レリーズベアリングは純正の新品に交換し、各摺動部には純正指定のグリースを適量
塗布して下さい。
また、プッシュ式の場合、レリーズベアリングとクラッチスリーブを別紙に指定の純正部品に交換
を行って下さい。
詳しくはカーメーカー発行の整備書に従って、なるべく水平な状態で作業下さい。

Replace the T/M.

For the pull type, replace the release bearing with the genuine new one, and apply specified

genuine grease to the sliding surfaces appropriately.

For the push type, replace the release bearing and the clutch sleeve with the genuine ones

specified in the separate sheet.

Follow the maintenance manual issued by the vehicle manufacturer.

注意
CAUTION

T/M 組み付け時、メインドライブシャフト先端で、クラッチディスクのスプライ
ン部をこじったり、変形させない様十分注意下さい。切れ不良やディスク破損の
原因になります。
Do not hit the spline teeth with the edge of the main drive shaft. It will cause

disengagement problems or damage to the clutch disc.

8.

ストローク調整
当キットに交換した場合、ペダル位置(切れ点及び繋がり点)が変化する場合があります。この場
合はペダル調整を行って下さい。
詳しくはカーメーカー発行の整備書に従って下さい。

Stroking

adjustment

After installing of this kit, the pedal position (engagement or disengagement point) may change.

Adjust the pedal according to the maintenance manual issued by the vehicle manufacturer.

Advertising
This manual is related to the following products: