レリーズベアリング取付け手順, Release bearing installation procedure – EXEDY Standard Multi User Manual
Page 9

M300 -
9
-
3.
プル系ホンダ車のレリーズベアリング取付け
Installation of release bearing to pull type Honda vehicle
レリーズベアリングを構成図①のクラッチカバーAssy に取り付けます。必ず安定した台上で作業して
ください。
Install the release bearing to the clutch cover Assy No. 1. Be sure to work on a stable bench.
レリーズベアリング取付け手順
(ベアリングを容易に取付けるため、以下の手順に従って作業願います。)
Release bearing installation procedure
(To install the bearing easily, follow the instructions below.)
1. Remove the clutch disc [4A], and place the
spacers at the three positions equally in
reference to the drawing below (positions of
the plate spring on the center plate).
Temporarily insert the release bearing from
the inside of the clutch cover.
2.
Tighten the bolts A [7] in the structural
drawing diagonally not at a time, but
for several times with equal force, until
the flywheel comes in contact with the
clutch cover.
As the bolt is tightened up, the lever is
raised up. The lever tip should be fit to
the proper groove of the bearing.
3. When the bolt A [7] in the
structural drawing is loosened
while the bearing is supported
with your hand, the lever is
lowered, and the bearing is fixed.
Use a spacer with a diameter of approximately
20 mm and thickness between 6.5 mm and 7.0
mm.
It is acceptable that nuts or washers piled up to
fit to the space are used as substitutes.
As the lever is raised, the inner diameter of
the lever tip is increased, and the bearing
can be easily set to the proper position.
4.
フライホイール(F/W)の取付け
Installation of flywheel (F/W)
1) 日産車、トヨタ車、スバル車、三菱車、ホンダ車
構成図⑥の F/W の取付けは一覧表にて指定のクランクボルト(FW 取付けボルト)を必ず御使用下
さい。
Nissan, Toyota, Subaru, Mitsubishi, and Honda vehicles
At the time of installation of the flywheel No. 6, be sure to use the crank bolt (flywheel mounting
bolt) specified on the list.
トヨタ車のクランクボルトのねじ山部には、必ずアドヘシブ 1324 を塗布して締め付けてくださ
い。
塗布せずそのまま締め付けるとエンジンオイルがボルト穴よりにじみ出ます。
Bearing temporarily
inserted
Spacer
Bolt A
Bolt A
Bearing