EXEDY Standard Multi User Manual
Page 14

M300 -
14
-
《アドバイス》
«Advice»
z ペダル位置を深くしたい場合(床側に近付ける)
マスターシリンダー部のプッシュロッドを短く調整し、フリー時のペダル高さを下げる方向に調整
する。
If the pedal position should be moved towards the floor, adjust the push-rod of the master cylinder
in the manner the pedal height is down in free position.
z ペダル位置を高くしたい場合(床から遠くする)
上記と逆の方向に調整する。
If the pedal position should be moved away from the floor, adjust the push-rod in the opposite to
the above.
レリーズベアリング及びクラッチスリーブ(日産車プッシュ式用)
Release bearing and clutch sleeve (for Nissan push type)
z レリーズベアリングは 7 ページに記載の当社指定品を別途購入しご準備下さい。
Additionally purchase the release bearing specified by us on page 7.
z クラッチスリーブの選択
クラッチスリーブは各車両別に、純正クラッチ装着時(新品時)とレリーズフォークの傾きが同じ
になるスリーブ長さのものを御使用下さい。
Selection of clutch sleeve
Use the clutch sleeve whose sleeve length allows the same inclination of the release fork as that in
the case the genuine clutch (new one) is installed, appropriate for each vehicle.
【日産車】[Nissan vehicle]
クラッチ品番
Clutch model
適応車種
Applicable vehicle
model
推奨スリーブ長
Recommended sleeve
length
NM01
NM02
S14 (SR20DET)
S15 (SR20DET)
24∼26 mm
NM03 R32
(RB26DETT)
14∼16 mm
NM06 Z32
(VG30DETT)
22∼24 mm
* 車輌によって個体差が有りますので現車での確認をお願い
します。
Since all the vehicles are individual, check the clutches
and release bearings with installed to them actually.
Sleeve length
Bearing
Press-in