FASS FA F15 125G - Manual (Page 15)

H. Measure between the two factory return fittings and cut remaining FL-1002. Insert two PLB-12516 fit-
tings into the FL-1002 using oil. Insert this assembly into factory return lines until you hear a click. Se-
cure fuel line.
G. Route the fuel line from the “E” port of the FASS to the engines fuel feed line quick disconnect and cut
to length. Insert the PLB-1238 into FASS fuel line using oil. Slide the PLB-1238 into the factory quick
disconnect until you hear a click. Lockdown factory retainer clip.
E. Drain fuel from factory pump/filter using a 6mm hex drive, turning it
counterclockwise.
F. Using quick disconnect tools, remove the fuel lines from the front of the factory fuel pump. Remove the
fuel lines attached to the rear of the factory fuel pump by pressing in on the blue tabs.
Note: Secure all fuel lines with cable ties. Cable ties are an economical way to prevent the
possibility of problems occurring!