FASS FA F15 125G User Manual
Page 8
A. Disconnect battery before beginning installation. Using ring terminals,
attach red wire of the WH-1005 to the positive battery terminal. The
use of corrosion preventative spray is recommended. Attach green
wire to a clean ground, preferably the negative battery terminal. Secure
fuse block in a location protected from outside elements.
B. Secure Relay in an upright position, as shown, to prevent moisture
from entering. Di-electric grease may be applied to prevent corrosion.
C. Attach WE-1001 to the WH-1005 Wiring Harness. Route WE-1001
red lead and the WH-1005 along the frame to the factory lift pump.
Completion of this step will be addressed in the Mounting Step.
The installation of the electrical harness is done first, allowing power to be applied to the pump for
lubrication purposes later in the installation.