FASS FA C09 150G - Manual (Page 10)

D. Using oil, insert PLB-1212 into one end of the provided FL-1002
fuel line. Feed line over frame to the stock fuel connection.
A. If necessary, carefully bend the sheet metal down that is cov-
ering the side.
Some of the photo’s are of a different application, procedures are the same.
C. Using a fuel line disconnect tool, disconnect the factory suction line located above the fuel cooler.
Place the disconnect tool around the fuel tube and slide the tool under the fuel line connection to re-
lease the fuel line. Pinch in tabs on 2011-Present models.
2011-Present
B. This step can be omitted on 2011–Present models. Remove the 3 bolts holding the fuel cooler to the
mounting bracket. The fuel cooler is located in front of the fuel tank.