FASS FA C09 150G User Manual
Page 14
A.
Route suction line from Step 2e to port ‘T’. Cut FL-1002 to
needed length. Using oil, insert PL-1005 and connect to 10-300
in port ’T’. Torque to 18 ft./lbs.
Do Not use sealant on AN (male flare) fittings. Only use sealant on threads installed into pump assembly.
Note: When installing Push-Lok fittings into fuel line, use oil on fittings and in the line.
B.
Install in-line fuel filter in an accessible location in the suction
line using the HC-1001’s. Making sure the fuel flow travels the
direction of the arrow on the canister.
C.
Measure from the factory feed connection from Step 2d to the ‘E’ port of the FASS system. Cut and
insert PL-1005. Connect to the 10-300 in the ‘E’ port of the FASS system. Torque to 18 ft./lbs.
2001-2010
2011-Present
E.
Carefully re-bend sheet metal back to original shape to protect
fuel tank, if needed.
D.
Reassemble fuel cooler on 2001-2010 models.
Note: Secure all fuel lines with cable ties. Cable ties are an economical way to prevent the
possibility of problems occurring!
Note: Inline filter will need to be replaced every 6,000 miles.