Freedom Designs Freedom NXT - Manual (Page 27)

Freedom Designs, Inc. Freedom Designs, Inc.
25
NXT
Generation NEXT
TM
Main Frame
Angle Adjustable Footboard
1. To attach the footboard to the frame, place
the footboard clamps on the frame. Set the
clamps at the desired height. Insert the
receiver into the clamps and tighten the 2
hex head screws on each side.
2. To remove the footboard for transfer, screw the
knob assemblies underneath the receivers.
Lift the footboard upward, out of the receivers.
3. To attach the footboard after transfer, align
the
footboard fi ttings into the receivers. Turn
the knobs on each side to tighten.
4. To change the angle of the footboard, use an
allen wrench and loosen the fl at head screws
on the top of the footboard. When the desired
angle or depth is reached, tighten both screws.
5. To change the height of the footboard on the
frame, loosen the 2 hex head screws on the
footboard frame clamps. Set the desired
height and tighten.
The lowest point of the footrest plate should
be at least 2 1/2” from the ground to ensure
the proper clearance.
Warning:
In all footplate and hanger adjustments, be
sure that all screws are tightened securely
for your safety.