Freedom Designs Freedom NXT - Manual (Page 29)

Freedom Designs, Inc. Freedom Designs, Inc.
27
NXT
Generation NEXT
TM
Main Frame
Casters
The
NXT
comes shipped with either 3” polyure-
thane casters with a 3” caster fork or 5”, 6”, 7”
pneumatic casters with 6” caster fork.
Push or Pull to Lock Wheel Locks
The NXT comes standard with push to lock or
pull to lock wheel locks.
To lock wheels in place:
1. Grasp the lever of the wheel lock with your
hand.
2. Pull or push the lever back or forward to
release the wheel lock.
Always set the wheel locks when entering or
leaving the wheelchair. Wheel locks are not
designed to slow the wheelchair down when
it is moving. Wheel locks hold the wheelchair
in place when it is at a complete stop.
CAUTION CAUTION ! !
Dual Post Fixed Height Armrest
1. To remove the armrest, lift the release lever
at the front of the seat frame and lift the arm
out of the arm receiver tubes.
2. To replace the arm, insert the arm into the
receiver tubes and rotate the release lever
to the downward position.
Dual Post Flip Back Adjustable Height
Armrest
1. To fl ip the arm back, rotate the release lever
at the front of the seat frame, upward to the
horizontal position. The arm is now free to rotate
backward.
2. To adjust the arm height, flip the release
lever (under the front of the arm pad) to
the horizontal position. Slide the arm upward
to the desired location. Flip the release
lever back to the vertical position.
3. To remove the arm, flip the front release
lever to the horizontal position and pull
the pin from the rear receiver tube.