Dynamic driving control, Dynamic driving control 103, Dsc dynamic stability con‐ trol 103 – BMW 760Li Sedan 2010 User Manual

Page 103: Traction and sport+ programs of the, Dynamic driv

Advertising

Initializing

In rare cases, it may become necessary to initi‐
alize the Integral Active Steering.

The warning lamp lights up. A message
appears on the Control Display.

With the engine running, turn the steering
wheel all the way to the left and right several
times in a uniform manner until the warning
lamp disappears.

Have the system checked if the warning
lamp does not go out after moving the steer‐
ing wheel approx. 6 times or if the steering
wheel is at an angle.

Using snow chains

Ensure that the rear axle steering is deactivated
when

using snow chains, refer to page 231

Programs

The system offers two different programs.
The programs can be selected via

Dynamic Driv‐

ing Control, refer to page 103

SPORT

Consistently sporty tuning of the Integral Active
Steering for greater driving agility.

NORMAL

Balanced tuning of the Integral Active Steering
for optimal traveling comfort.

Malfunction

In the event of a malfunction, the steering wheel
must be turned further, while the vehicle re‐
sponds more sensitively to steering wheel
movements in the higher speed range.
The stability-enhancing intervention may be de‐
activated.
Proceed cautiously and drive defensively.
Have the system checked.

Dynamic Driving Control

The concept

Dynamic Driving Control can be used to adjust
the driving dynamics of the vehicle. Several pro‐
grams are available for this purpose; they can be
activated using the two Dynamic Driving Control
buttons.

Operating the programs

Press the button

Program

DSC OFF
TRACTION

SPORT +
SPORT
NORMAL
COMFORT*

For Dynamic Damper Control*, the lower button
is labeled with COMFORT.

Automatic program change

The system automatically switches to NORMAL
in the following situations:

▷

Failure of Integral Active Steering*.

▷

Failure of Dynamic Damping Control*.

▷

The vehicle has a flat tire.

DSC OFF

Driving stability is limited during acceleration
and when driving in bends.
Stabilizing interventions by the Integral Active
Steering* system are only performed by the rear
axle steering.
To increase vehicle stability, activate DSC again
as soon as possible.

Activating DSC OFF

Press and hold the button, but not lon‐
ger than approx. 10 seconds, until the

indicator lamp for the DSC lights up in the in‐

Seite 103

103