Alarm system, Alarm, Is triggered if the – BMW 760Li Sedan 2010 User Manual

Page 41

Advertising

Functional requirements

▷

To lock the vehicle, the remote control must
be located outside of the vehicle.

▷

The next unlocking and locking cycle is not
possible until after approx. 2 seconds.

▷

The engine can only be started if the remote
control is inside the vehicle.

Comparison with ordinary remote

control

The functions can be controlled by pressing the
buttons or via Comfort Access.

Releasing

Fully grasp a door handle, arrow 1. This corre‐
sponds to pressing the button.

Locking

Press the area on the door handle, arrow 2, with
your finger for approx. 1 second.
This corresponds to pressing the button.
To save battery power, ensure that the ignition
and all electronic systems and/or power con‐
sumers are switched off before locking the ve‐
hicle.

Unlocking the trunk lid separately

Press the button on the exterior of the

trunk lid,

refer to page 38

This corresponds to pressing the

button.

If a remote control accidentally left in the trunk
is detected in the locked vehicle, then the trunk
lid opens again.

Ignition on

Pressing the Start/Stop button switches the ig‐
nition on.
When doing so, do not depress the brake pedal;
otherwise, the engine will start.

Malfunction

Comfort Access may not function properly if it
experiences interference from local radio waves,
e.g., mobile phones.
If this occurs, open or close the vehicle using the
buttons on the remote control or use a key in the
door lock.
To subsequently start the engine, hold the re‐
mote control against the marked

area on the

steering column, refer to page 33

Alarm system*

The concept

The vehicle alarm system responds to:

▷

Opening of a door, the hood or the trunk lid.

▷

Movements in the vehicle:

interior motion

sensor, refer to page 42

▷