Transmission operation while plowing, Driving – FORD 2006 F-550 v.1 User Manual

Page 199

Advertising
background image

certain frontal and offset frontal collisions when the vehicle sustains
sufficient longitudinal deceleration.

Careless or high speed driving while plowing snow which results in
sufficient vehicle decelerations can deploy the airbag. Such driving also
increases the risk of accidents.

All occupants of the vehicle, including the driver, should always
properly wear their safety belts, even when an air bag

supplemental restraint system (SRS) is provided.

Never remove or defeat the “tripping mechanisms” designed into the
snow removal equipment by its manufacturer. Doing so may cause
damage to the vehicle and the snow removal equipment as well as
possible airbag deployment.

Do not attempt to service, repair, or modify the air bag
supplemental restraint system (SRS) or its fuses. See your Ford

or Lincoln Mercury dealer.

Additional equipment such as snowplow equipment may effect
the performance of the airbag sensors increasing the risk of

injury. Please refer to the Body Builders Layout Book for instructions
about the appropriate installation of additional equipment.

Transmission operation while plowing

Operate the vehicle with the automatic transmission gearshift lever in
the D (Overdrive) position and Tow/Haul OFF.
• Shift transfer case to 4x4 LOW (4WD Low) when plowing in small

areas at speeds below 5 mph (8 km/h).

• Shift transfer case to 4x4 HIGH (4WD High) when plowing larger

areas or light snow at higher speeds. Do not exceed 15 mph
(24 km/h).

• Do not shift the transmission from a forward gear to R (Reverse) until

the engine is at idle and the wheels are stopped.

• If the vehicle is stuck, shift the transmission in a steady motion

between forward and reverse gears. Do not rock the vehicle for more
than a few minutes. The transmission and tires may be damaged or
the engine can overheat.

2006 F-250/350/450/550 (f23)
Owners Guide (post-2002-fmt)
USA
(fus)

Driving

199

Advertising
This manual is related to the following products: