NISSAN 2013 Quest - Navigation System Owner's Manual - Manual (Page 124)

Black plate (124,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
6-10 Storing location/route
Name (only for stored locations)
Changes the name of a stored location.
1. Highlight [Edit] and push <ENTER>.
2. Highlight [Name] and push <ENTER>.
A character input screen is displayed.
3. Enter the preferred name for the stored
location.
“How to input letters and numbers”
(page 2-15)
4. Highlight [OK] and push <ENTER>.
The name is stored.
Voicetag (only for stored locations)
Stores the voicetag for the stored location. The
voicetag allows you to set the stored location as
a destination using Voice Recognition.
1. Highlight [Voicetag] and push <ENTER>.
2. Highlight [Store] and push <ENTER>.
3. A beep sounds, and the system enters the
voice command reception mode.
4. Speak the name/word to be used as
Voicetag.
5. The Voicetag is stored, provided the system
recognizes it.
INFO:
. A Voicetag cannot be stored, overwritten or
played while driving.
. The Address Book can store up to 100
Voicetags.
. Highlight [Play] to confirm the stored Voice-
tag.
. Highlight [Delete] to delete a stored Voice-
tag.
. If a Voicetag is already stored, select
[Restore] to re-record the Voicetag.