NISSAN 2012 Altima Sedan - Owner's Manual - Manual (Page 223)

DISP button:
The display screen can be turned off by pressing
the DISP button. You can listen to music while the
display is off. If you want to turn the screen on,
either press the DISP button or press the FM·AM,
XM or CD·AUX button.
Switching the display:
Pressing the CD·AUX button switches the dis-
plays as follows:
CD → iPodா/USB → AUX → CD
FM-AM-SAT radio operation
Radio (FM/AM) band select:
Press the radio band select button to change the
band as follows:
AM → FM1 → FM2 → AM
XM radio (SAT) band select:
Press the radio band select button to change the
band as follows:
XM1 → XM2 → XM3 → XM1
When the radio band select button is pressed
while the ignition switch is in the ACC or ON
position, the radio will come on at the channel last
played.
The last channel played will also come on when
the PWR button is pressed to ON.
The satellite radio is not available in Alaska, Ha-
waii and Guam.
If another audio source is playing when the radio
band select button is pressed, the audio source
automatically turns off and the last radio channel
played comes on.
When the stereo broadcast signal is weak, the
radio automatically changes from stereo to mon-
aural reception.
TUNE (Tuning):
● For AM and FM radio
Turn the radio TUNE dial for manual tuning.
● For XM Satellite Radio
Turn the radio TUNE dial to seek channels
from all of the categories when any category
is not selected.
SEEK tuning/CAT
(category):
● For AM and FM radio
Press the SEEK button or to
tune from low to high or high to low frequen-
cies and to stop at the next broadcasting
station.
● For XM Satellite Radio
Press the SEEK button or to
tune to the first channel of the next or previ-
ous category.
SCAN tuning:
Press the SCAN tuning button to tune from low
to high frequencies and stop at each broadcast-
ing station/channel for 5 seconds. Pressing the
button again during this 5 seconds period will
stop SCAN tuning and the radio will remain tuned
to that station/channel.
If the SCAN tuning button is not pressed within 5
seconds, SCAN tuning moves to the next
station/channel.
᭺
1 to
᭺
6 Station memory operations:
12 stations/channels can be set for the FM band
(6 each for FM1 and FM2), 12 for XM radio (6
each for XM1 and XM2) and 6 stations can be set
for the AM band.
1. Choose the radio band using the radio band
select button.
2. Tune to the desired station/channel using
the SEEK·CAT, SCAN button or the radio
TUNE dial.
3. Press and hold the desired station preset
button
᭺
1 to
᭺
6 until the radio beeps.
4-56 Monitor, climate, audio, phone and voice recognition systems