Before starting -5 giving voice commands -5 – NISSAN 2012 Altima Sedan - Navigation System Owner's Manual User Manual

Page 239

Advertising
background image

BEFORE STARTING

To get the best recognition performance from
Voice Recognition, observe the following items.

● The interior of the vehicle should be as quiet

as possible. Close the windows to eliminate
the surrounding noises (traffic noise and vi-
bration sounds, etc.), which may prevent the
system from correctly recognizing the voice
commands.

● Wait until the tone sounds before speaking a

command.

● Speak in a natural conversational voice with-

out pausing between words.

GIVING VOICE COMMANDS

1. Press

located on the steering wheel

switch.

2. A list of commands appears on the screen,

and the system provides the voice menu
prompt “Would you like to access Phone,
Navigation, Information, Audio or Help?”.

3. After the tone sounds and the icon on the

screen changes from

to

,

speak a command.

4. Continue to follow the voice menu prompts

and speak after the tone sounds until the
preferred operation is completed.

Operating tips

● Speak a command after the tone.
● Commands that are available are always

shown on the display and spoken through
voice menu prompts. Commands other than
those that are displayed are not accepted.
Follow the prompts given by the system.

● If the command is not accepted, the system

announces, “Please say again”. Repeat the
command in a clear voice.

● Press “Back” once to return to the previous

screen.

● To cancel the command, press and

hold

. The message, “Voice cancelled”

will be announced.

● Press

to stop the voice prompt and

give the command at once. Remember to wait
for the tone before speaking.

● To adjust the volume of the system feedback,

push the volume control buttons “+” or “

Ϫ” on

the steering wheel switch or use the audio
system volume knob while the system is mak-
ing an announcement.

How to speak numbers

NISSAN Voice Recognition requires a certain
way to speak numbers when giving voice
commands. Refer to the following examples.

General rule:

Only single digits 0 (zero) to 9 can be used. For
example, if speaking 500, “five zero zero” can be
used, but “five hundred” cannot.

NVR0006

Voice recognition

9-5

Advertising
This manual is related to the following products: