NISSAN 2013 Cube - Owner's Manual - Manual (Page 277)

Black plate (275,1)
[ Edit: 2012/ 7/ 19 Model: Z12-D ]
JUMP STARTING
If jump starting is necessary, see “Jump starting”
(P.6-10). If the engine does not start by jump
starting, the battery may have to be replaced.
Contact a NISSAN dealer. CAUTION
. Do not ground accessories directly
to the battery terminal. Doing so will
bypass the variable voltage control
system and the vehicle battery may
not charge completely.
. Use electrical accessories with the
engine running to avoid discharging
the vehicle battery.
The variable voltage control system measures
the amount of electrical discharge from the
battery and controls voltage generated by the
generator.
SDI2422
1. Drive belt auto-tensioner
2. Crankshaft pulley
3. Air conditioner compressor
4. Water pump
5. Alternator
WARNING
Be sure the ignition switch is in the OFF
or LOCK position before servicing drive
belts. The engine could rotate unex-
pectedly.
1. Visually inspect the belt for signs of unusual
wear, cuts, fraying or looseness. If the belt is
Maintenance and do-it-yourself 8-15
VARIABLE VOLTAGE CONTROL
SYSTEM (if so equipped)
DRIVE BELT
Condition: