NISSAN 2011 LEAF - Dismantling Guide - Manual (Page 13)

3. Preparation for Dismantling
• Failure to properly shut down the high voltage electrical system before the
Dismantling Procedures are performed will result in serious injury or death from
electrical shock. To prevent serious injury or death, DO NOT touch high voltage
harnesses or components without wearing appropriate PPE.
• If it is necessary to touch any of the high voltage harnesses or components you
must wear appropriate PPE to avoid electrical shock. Shut down the high voltage system
by following the steps outlined in
3-3 High Voltage System Shut-Down Procedure. Wait
at least ten (10) minutes for complete discharge of the high voltage capacitor after the
high voltage system has been shut down.
• NEVER assume the LEAF is shut OFF simply because it is quiet.
• If it becomes necessary for the dismantler to leave the vehicle, place a “DANGER”
sign (for example, refer to 4-4 Storing the Vehicle ) on the vehicle to alert other people
that the vehicle contains a high voltage battery.
• If the READY indicator, charging indicator or air conditioning remote timer
indicator are ON the high voltage system is active.
• If possible, be sure to verify that the READY indicator on the instrument
cluster is OFF and the high voltage system is stopped.
3-1 Discharging Procedures
Do not perform this procedure if the battery is damaged. If you are unsure of battery
damage, use extreme caution and wear appropriate PPE.
Li-ion battery discharging must take place before dismantling. Sufficient discharging can be achieved by
following these steps.
1. Place the selector lever into the Park (P) position
2. Apply the parking brake.
3. Set wheel chocks to ensure the vehicle is completely stopped.
13