NISSAN 2015 LEAF - Owner's Manual User Manual

Page 324

Advertising
background image

If the 12-volt battery is discharged, the
power switch cannot be moved from the
OFF position. Connect the jumper cables
to the booster vehicle

B

before pushing

the power switch.

3. Push the P (Park)position switch to place the

vehicle in the P (Park) position.

4. Switch off all unnecessary electrical systems

(headlights, heater, air conditioner, etc.).

5. Place the power switch in the OFF position.

6. Remove the vent caps on the 12-volt battery

(if so equipped). Cover the battery with a
firmly wrung out moist cloth to reduce the
hazard of an explosion.

7. Connect jumper cables in the sequence as

illustrated (

1

2

3

4

).

CAUTION

• Always connect positive (+) to positive

(+) and negative (−) to body ground (for
example, as illustrated), not to the 12-
volt battery.

• Make sure the jumper cables do not

touch moving parts in the motor com-
partment and that the cable clamps do
not contact any other metal.

8. Start the engine of the booster vehicle

B

.

9. While the booster vehicle

B

engine is run-

ning, place the EV system in the READY to
drive position.

CAUTION

If the system does not start right away,
push the power switch to the OFF posi-
tion and wait 10 seconds before trying
again.

10. After starting your EV system, carefully dis-

connect the negative cable and then the
positive cable (

4

3

2

1

) and

keep the READY to drive position over 20
minutes to charge the 12-volt battery.

11. Replace the vent caps (if so equipped). Be

sure to dispose of the cloth used to cover
the vent holes because it may be contami-
nated with corrosive acid.

12. If necessary, connect the vehicle to a charg-

ing station or EVSE (Electric Vehicle Supply
Equipment) to charge the Li-ion battery.
(See “Charge” section.) The vehicle can not
be driven until the Li-ion battery is charged.

NOTE:
If it is not possible to turn the system ON by
following this procedure, contact a NISSAN
certified LEAF dealer immediately.

If the power limitation indicator light

illumi-

nates, the traction motor output is limited result-
ing in reduced vehicle speed. Stop the vehicle in
a safe location before the Li-ion battery becomes
completely discharged and no power is available
to drive the vehicle. Contact Roadside assis-
tance; see your NISSAN Warranty Information
Booklet.

If possible, place the power switch in the OFF
position while waiting for assistance to prevent
discharging the 12-volt battery.

NOTE:
If the Li-ion battery becomes completely
discharged:

The vehicle is automatically placed in the

ON position and it will not be possible to
switch to the READY position.

The vehicle is automatically switched to

the N (Neutral) position and it will not be
possible to drive the vehicle.

WARNING

If the vehicle is in the N (Neutral) position
and the Li-ion battery and the 12-volt
battery become completely discharged,
the vehicle can not be placed in the P

IF THE LI-ION BATTERY BECOMES
COMPLETELY DISCHARGED

In case of emergency

6-11

Advertising