Navigation – NISSAN 2015 Murano - Navigation System Owner's Manual User Manual
Page 104
6. Navigation
.
Touch [Add New] to add a new location.
4. The selected destination is displayed. Touch
[Start] to start route guidance.
Voice command
1. Push <
> located on the steering wheel.
2. After the tone sounds, speak a command.
Use the following voice command to set a
destination from the Address Book:
“Address Book”
SEARCHING FROM PREVIOUS
DESTINATIONS
A previous destination and a previous start point
can be set as the destination.
Up to 100 previous destinations will be auto-
matically stored. If the number of previous
destinations exceeds 100, the oldest one will
be replaced by the newest one.
1. Touch [Navi] on the Launch Bar.
2. Touch [Previous Destinations]. A list screen
is displayed.
3. Touch the previous destination or a previous
start point from the list.
4. Touch [Start] to start route guidance.
Voice command
1. Push <
> located on the steering wheel.
2. After the tone sounds, speak a command.
Use the following voice commands to display the
previous destinations/start point list:
“Previous Destinations”
“Previous Start Point”
SETTING INTERSECTION
It is possible to set an intersection of any two
streets as the destination and have the system
calculate a route.
1. Touch [Navi] on the Launch Bar.
2. Touch [Intersection]. Intersection screen is
displayed.
3. Input the Intersection.
.
Touch [State/Province] to enter the state
or province name if necessary.
.
Touch [City] to enter the city name.
.
Touch [1st Street] to enter the first street
name. After finishing the entry, touch
[List]. A list screen is displayed.
.
Touch [2nd Street] to enter the second
street name. After finishing the entry,
touch [List]. A list screen is displayed.
4. When information about state, city, and
street are entered, the destination is pro-
posed on the touch screen display. Touch
[OK].
5. The selected destination is displayed at the
center of the map. Touch [Start] to start route
guidance.
Voice command
1. Push <
> located on the steering wheel.
2. After the tone sounds, speak a command.
Use the following voice command to set an
intersection as destination:
“Intersection”*
*: This voice command operation is available only
when the language setting is set to English.
6-20