NISSAN 2013 Pathfinder - Owner's Manual - Manual (Page 29)

Install
1. Align the head restraint stalks with the holes
in the seat. Make sure the head restraint is
facing the correct direction. The stalk with
the adjustment notches
᭺
1 must be installed
in the hole with the lock knob
᭺
2 .
2. Push and hold the lock knob and push the
head restraint down.
3. Properly adjust the head restraint before an
occupant uses the seating position.
HEAD RESTRAINTS (2nd row)
WARNING
Head restraints supplement the other ve-
hicle safety systems. They may provide
additional protection against injury in cer-
tain rear end collisions. Adjust the head
restraints properly, as specified in this
section.
Check the adjustment after
someone else uses the seat. Do not attach
anything to the head restraint stalks or
remove the head restraint. Do not use the
seat if the head restraint has been re-
moved. If the head restraint was removed,
reinstall and properly adjust the head re-
straint before an occupant uses the seat-
ing position. Failure to follow these in-
structions can reduce the effectiveness of
the head restraints. This may increase the
risk of serious injury or death in a
collision.
The illustration shows the seating positions
equipped with head restraints. The second row
head restraints are removable and adjustable.
᭡ Indicates the seating position is equipped with
a head restraint.
Ⅲ Indicates the seating position is equipped with
an adjustable headrest.
LRS0891 LRS2135
1-12 Safety—Seats, seat belts and supplemental restraint system