NISSAN 2015 Pathfinder - Owner's Manual - Manual (Page 325)

“Outgoing”
᭺
A
Use the Outgoing command to list the outgoing
calls made from the vehicle.
“Incoming”
᭺
B
Use the Incoming command to list the incoming
calls made to the vehicle.
“Missed”
᭺
C
Use the Missed command to list the calls made to
the vehicle that were not answered.
“Call Back”
᭺
D
Use the Call Back command to dial the number of
the last incoming call to the vehicle.
“Redial”
᭺
E
Use the Redial command to dial the number of
the last outgoing call from the vehicle.
“Connect Phone”
NOTE:
The Add Phone command is not available
when the vehicle is moving.
Main Menu
“Connect Phone”
“Add Phone”
᭺
A
“Select Phone”
᭺
B
“Delete Phone”
᭺
C
“Turn Bluetooth OFF”
᭺
D
“Replace Phone”
᭺
E
Use the Connect Phone commands to manage
the phones connecting to the vehicle or to enable
the Bluetooth® function on the vehicle.
“Add Phone”
᭺
A
Use the Add Phone command to add a phone to
the vehicle. For additional information, refer to
“Connecting procedure” in this section.
“Select Phone”
᭺
B
Use the Select Phone command to select from a
list of phones connected to the vehicle. The sys-
tem will list the names assigned to each phone
and then prompt you for the phone you wish to
select. Only one phone can be active at a time.
“Delete Phone”
᭺
C
Use the Delete Phone command to delete a
phone that is connected to the vehicle. The sys-
tem will list the names assigned to each phone
and then prompt you for the phone you wish to
delete. Deleting a phone from the vehicle will also
delete the phonebook for that phone.
“Turn Bluetooth OFF”
᭺
D
Use the Turn Bluetooth OFF command to prevent
a wireless connection to your phone.
“Replace Phone”
᭺
E
Use the Replace Phone command to replace an
existing phone pairing with a new phone. The
system will keep all voice tags assigned to your
phonebook.
VOICE ADAPTATION (VA) MODE
Voice Adaptation allows up to two out-of-dialect
users to train the system to improve recognition
accuracy. By repeating a number of commands,
the users can create a voice model of their own
voice that is stored in the system. The system is
capable of storing a different voice adaptation
model for each connected phone.
Training procedure
The procedure for training a voice is as follows.
1. Position the vehicle in a reasonably quiet
outdoor location.
2. Sit in the driver’s seat with the engine run-
ning, the parking brake on, and the transmis-
sion in P (Park).
4-128 Monitor, climate, audio, phone and voice recognition systems