First drive features, Windshield wiper and washer switch – NISSAN 2014 Rogue - Quick Reference Guide User Manual

Page 16

Advertising
background image

14

To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

FIRST DRIVE FEATURES

WINDSHIELD WIPER AND WASHER SWITCH

Move the lever to the following positions to operate

the windshield wipers:

01

Mist

— One sweep operation of the

front wipers.

02

Intermittent

— Front wipers operate

intermittently and the speed can be adjusted
by twisting the time control ring

03

to

increase or decrease wiper speed.

04

Low

— Front wipers operate at a

continuous low-speed.

05

High

— Front wipers operate at a

continuous high-speed.

06

Front Washer

— Pull the lever toward you

to activate the front washer. The front wipers
will operate several times.

REAR WINDSHIELD WIPER AND WASHER

07

Intermittent

— Rear wiper operates

intermittently.

08

Low

— Rear wiper operates at a

continuous low-speed.

09

Rear Washer

— Push the lever forward

to activate the rear washer. The rear wiper will
operate several times.

WIPER BLADE REPLACEMENT PROCEDURE
The windshield wipers must be in the service position in order to replace the wiper blades.
To move the wiper blades to the service position, follow this procedure:
When the ignition switch is in the ON position or within 60 seconds of placing the

ignition switch to the OFF position, push the windshield wiper and washer lever up to
the Mist

position two times in less than 0.5 seconds. The windshield wipers will

move to the service position automatically, and the wiper blades can now be replaced.

To move the wiper blades back to the original position:
Pull the windshield wiper and washer lever up for more than 1 second or push the lever

down to operate at any wiper speed.

For more information, refer to the “Instruments and controls (section 2)” and the “Maintenance and do-it-yourself
(section 8)”
of your Owner’s Manual.

03

01

02

04

05

MIST

OFF

INT

LO

HI

06

09

INT

ON

07

08

LANE CHANGE SIGNAL
To signal a lane change, move the lever up or down to the point where the indicator light

begins to flash, but the lever does not latch.

The turn signal will flash 3 times automatically.

For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.

1766904_14d_Rogue_QRG_062514.indd 14

6/25/14 3:29 PM

Advertising