Windshield wiper and washer switch – NISSAN 2015 Rogue - Quick Reference Guide User Manual

Page 17

Advertising
background image

To view detailed instructional videos regarding these and other features,

please go to www.nissanownersinfo.mobi.

15

WINDSHIELD WIPER AND WASHER SWITCH

Move the lever to one of the following positions

to operate the windshield wipers:

1

Mist

— One sweep operation of the

front wipers.

2

Intermittent

— Front wipers operate

intermittently, and the speed can be
adjusted by twisting the time control ring

3

to increase or decrease wiper speed.

4

Low

— Front wipers operate at a

continuous low-speed.

5

High

— Front wipers operate at a

continuous high-speed.

6

Front Washer

— Pull the lever toward

you to activate the front washer. The front
wipers will operate several times.

REAR WINDSHIELD WIPER AND WASHER

7

Intermittent

— Rear wiper

operates intermittently.

8

Low

— Rear wiper operates

at a continuous low-speed.

9

Rear Washer

— Push the lever forward to activate the rear washer. The

rear wiper will operate several times.

WIPER BLADE REPLACEMENT PROCEDURE
The windshield wipers must be in the service position in order to replace the wiper
blades. To move the wiper blades to the service position, follow this procedure:
When the ignition switch is in the ON position or within 60 seconds of placing the

ignition switch to the OFF position, lift the windshield wiper and washer lever up to
the Mist

position

1

two times in less than 0.5 seconds. The windshield wipers will

move to the service position automatically, and the wiper blades can now be replaced.

To move the wiper blades back to the original position:
Lift the windshield wiper and washer lever up for more than 1 second or lower the

lever down to operate at any wiper speed.

For more information, refer to the “Instruments and controls (section 2)” and the “Maintenance and do-it-
yourself (section 8)”
of your Owner’s Manual.

3

1

2

4

5

MIST

OFF

INT

LO

HI

6

9

INT

ON

7

8

LANE CHANGE SIGNAL
To signal a lane change, move the lever up or down to the point where the indicator

light begins to flash but the lever does not latch.

The turn signal will flash 3 times automatically.

For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.

1758972_15b_Rogue_QRG_082614.indd 15

8/26/14 1:07 PM

Advertising