Nissan vehicle immobilizer system -27 – NISSAN 2014 Rogue Select - Owner's Manual User Manual

Page 99

Advertising
background image

Black plate (97,1)

[ Edit: 2013/ 10/ 22 Model: S35-D ]

security system is now pre-armed. After
about 30 seconds the vehicle security
system automatically shifts into the armed
phase. The security light begins to flash
once every approximately 3 seconds. If,
during this 30-second pre-arm time period,
the door is unlocked, or the ignition switch is
turned to the ACC or ON position, the
system will not arm.

Even when the driver and/or passengers
are in the vehicle, the system will activate
with all doors locked with the ignition
switch in the LOCK position. When turning
the ignition switch to the ACC or ON
position, the system will be released.

Vehicle security system activation

The vehicle security system will give the follow-
ing alarm:

.

The headlights blink and the horn sounds
intermittently.

.

The alarm automatically turns off after
approximately 50 seconds. However, the
alarm reactivates if the vehicle is tampered
with again.

The alarm is activated by:

.

Unlocking the door without using the keyfob,
or the key. (Even if the door is opened by
releasing the door inside lock knob, the

alarm will activate.)

How to stop an activated alarm

The alarm will stop by unlocking a door by
pushing the unlock button

on the keyfob, or

using the key. The alarm will not stop if the
ignition switch is turned to the ACC or ON
position.

If the system does not operate as de-
scribed above, have it checked by a
NISSAN dealer.

NISSAN VEHICLE IMMOBILIZER SYS-
TEM

The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of the
registered key.

If the engine fails to start using the registered
key, it may be due to interference caused by
another registered key, an automated toll road
device or automated payment device on the key
ring. Restart the engine using the following
procedures:

1. Leave the ignition switch in the ON position

for approximately 5 seconds.

2. Turn the ignition switch to the OFF or LOCK

position and wait approximately 10 seconds.

3. Repeat step 1 and 2 again.

4. Restart the engine while holding the device

(which may have caused the interference)
separate from the registered key.

If this procedure allows the engine to start,
NISSAN recommends placing the regis-
tered key on a separate key ring to avoid
interference from other devices.

Statement related to section 15 of FCC
rules for NISSAN Vehicle Immobilizer
System (CONT ASSY-BCM. ANT ASSY-
IMMOBILISER)

FCC Notice:

This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference that
may cause undesired operation.

NOTE:

Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.

Instruments and controls

2-27

Condition:

Advertising