NISSAN 2013 Titan - Owner's Manual - Manual (Page 166)

Removing the tailgate
1. Disconnect the wiring harness for the rear
camera (if so equipped). See “Disconnect-
ing the rear camera” in this section.
2. Release the tailgate support cables.
CAUTION
● The tailgate is heavy. Two people
should remove or install it. Be careful
not to drop it during removal.
● After releasing the support cables, do
not let the tailgate rest on the bumper.
3. Hold the tailgate at a 45 degree angle.
4. Pull the tailgate out from the left side hinge.
5. Slide the tailgate out of the right side hinge.
Installing the tailgate
1. Insert the tailgate into the right side hinge.
2. Hold the tailgate at a 45 degree angle and
insert into the left side hinge.
3. Continue to hold the tailgate at a 45 degree
angle and attach the tailgate support cables.
4. For vehicles with rear camera: Be sure the
tailgate harness is not hanging below the
tailgate and keep the tailgate open . See
“Connecting the rear camera” in this section
before closing the tailgate.
5. For vehicles without rear camera: Close the
tailgate securely.
LPD0271
Pre-driving checks and adjustments 3-23